In the event of an uncontrolled fall of the rig or in extreme situations such as a skid fall, the rig hits the protector first. During this contact, the energy generated is dissipated by deformation of the power joint (material elastomer). This allows the entire board to be better protected.

Prepared for assembly with 1-pole and 2-pole mast bases.

The deck protection pad (silicone rubber) protects the sensitive deck surface between the WBP and the surfboard.
Included in the standard set.

An optimized, geometric construction and simulation of the design structure saved material and reduced weight while achieving the required strength and function.

All common mast bases up to 122mm in diameter can be mounted thanks to the generously dimensioned mounting surface of the protector.

Compared to other solutions, the mass of the protector is close to the center of gravity of the board and therefore has little impact on balance and performance.

An eye-catcher thanks to the harmoniously chosen shape combined with an unusual choice of colors give your board that certain something.

At the base of the mast, the friction disc is replaced by the protector and mounted as usual.

Freestyle maneuvers are not affected by geometrically-caused interfering contours.

The adjustment range of the mast rail remains the same.

The water start is made easier by the shape of the protector and the resulting lift-up effect (raising the sail towards the starting position).

Handling in the water is hardly affected by the flowing shape.